📁
Master DNL Class4 Version 5
  • Introduction
  • Support
  • First Time Setup
    • Create Vendor
    • Create Routing
      • Routing Plan
      • Static Route
      • Dynamic Route
    • Create Client
    • Call Simulation
    • Check CDR
    • Check Report
    • Check PCAP
    • Setup ANI Rotation
    • Set Min Call Duration
    • Block Calls by DNC
  • Maintainence
    • Update US LERG in Switch
    • How to manage PCAP cleaning
    • How to manage CDR cleaning
      • Using dnl_backup_tool
      • Using dnl_cloud_tool
  • Troubleshoot
    • Getting "Missing table" error during invoice generation
    • Switch can't process more than 30K ports
    • How many calls are client sending
    • Call Failure
    • Enforce Valid DNIS Length
    • Enforce E164 Format for Vendor Trunk
    • Configure VoIP Switch in UI
    • SIP Switch is Down
    • Validate Auto-Invoice Rule
  • Installation
    • Installation with RPM
Powered by GitBook
On this page

Was this helpful?

  1. First Time Setup

Call Simulation

PreviousCreate ClientNextCheck CDR

Last updated 4 years ago

Was this helpful?

Introduction

After you set up your routing then normally you want to validate to check your routing. Call Simulation is the tool for that. Within Call Situation, you can enter the Ingress Trunk, ANI, and DNIS. Then, Class 4 will tell you which Egress trunks will terminate the calls to.

Step 1: Open Call Simulation page

Now, you see the following and this is where you specify the ingress trunk, ANI, and DNIS:

Step 2: Specify your test information

After you click Submit, you will see the following results: